5.2 Settings from the Menu
Note:
- When the new model name cannot be loaded from the
lens, "READ ERROR" appears on the bottom instead of
"COMPLETED."
- When the rotary pulse switch is turned to switch the cursor on
"CANCEL" to "CLR" and the SET button is pressed in Step
M2, "COMPLETED" appears on the bottom.
Next, when "COMPLETED" disappears, the area to display
a model name automatically obtained from the lens will be
blank.
Note:
The lens name used for "AUTO SEL" can be edited so that the lens file can be shared with a similar lens.
The following explains the procedures.
E1
Follow Steps 1 to 3 of lens file creation to display the submenu.
E2
Turn the rotary pulse switch to position the cursor
on "NUMBER", and press the SET button.
The registered lens numbers (NO. 1 to NO. 8) are
displayed.
E3
Turn the rotary pulse switch to position the cursor
on the lens number of the file name to be edited,
and press the SET button.
The NO.5 lens set in "AUTO SEL" is selected here as
an example and the AUTO SEL NAME display part
displays "AB40X10 ABCD".
92
NUMBER OFF
NAME ( )
MODEL AUTO READ
EXTENDER OFF
AUTO SEL OFF
FILE SET MANUAL
LENS TYPE ***
LENS NO.1
READ ERROR
NUMBER OFF
NAME ( )
MODEL CLR
EXTENDER OFF
AUTO SEL OFF
FILE SET MANUAL
NUMBER NO.1
NAME ( )
MODEL AUTO READ
EXTENDER OFF
AUTO SEL OFF
FILE SET MANUAL
LENS TYPE ***
LENS NO.1
COMPLETED
NUMBER OFF
NAME ( )
( )
EXTENDER OFF
AUTO SEL OFF
FILE SET MANUAL
LENS TYPE ***
LENS NO.1
LENS SELECT
NUMBER
NAME ( )
( )
EXTENDER
AUTO SEL
FILE SET
LENS TYPE
AUTO X0.8 CONV
X0.8 CONV CONT
LENS SERIAL I/F
LENS SELECT
NUMBER
NAME ( )
(AB40X10 ABCD )
EXTENDER
AUTO SEL
FILE SET
HDK-55 1206 VER1 (U)
When the new model
name cannot be
loaded
Switch the cursor to
"CLR" and confirm.
"COMPLETED"
appears.
The area will be blank.
E②
OFF
Position the cursor on
"NUMBER" and confirm.
OFF
OFF
OFF
***
OFF
OFF
OFF
E③
NO.5
Select the target lens
number and confirm.
OFF
OFF
OFF