Ikegami HDK-55 Operation Manual page 102

5.2 Settings from the Menu
Menu Item
FAN CONTROL
FAN CONT MODE
HEAD TOP
ADAPTOR
VF CONT
FAN CONDITION
HEAD TOP
ADAPTOR
H PHASE CONTROL
H PHASE
TIME SETTING
TIME
DATE (YY/MM/DD)
MEMORY CARD
SAVE FILE
ALL DATA
SNAP SHOT
SCENE
REFERENCE
LENS
LOAD FILE
ALL DATA
SNAP SHOT
SCENE
REFERENCE
LENS
MENU DATA
■ MENU (3/3)
Menu Item
SCAN FORMAT SELECT
SCAN MODE
CPU SYSTEM CONTROL
SEMI SELF MODE
SEMI REMOTE MODE
86
Initial
Setting value
setting
AUTO, SLOW, QUIET,
AUTO
STOP
---
--- (information display)
---
---
(information display)
---
0.0 -100 to +100
--- HH : MM : SS
--- YY / MM / DD
---
---
---
---
---
---
---
--- ALL, SELECT NUMBER
---
--- ALL, SELECT NUMBER
--- ALL, VF
Initial
Setting Value
Setting
Destination
1080I59, 1080I50
setting
ON OFF, ON
OFF OFF, ON
HDK-55 1206 VER1 (U)
Description, Remarks
AUTO ： Automatically changes the cooling fan speed
according to the internal temperature level.
SLOW ： Sets the fan to SSLOW for 5 minutes. After 5
minutes, the mode changes to AUTO.
QUIET ： Stops the fan until the external temperature becomes
about 35 ℃ . Above that temperature the fan is
operated automatically.
STOP ： Keeps the fan stopped as long as the internal
temperature does not reach a critical level. If the
power is turned on again, it returns to AUTO.
If the QUIET, STOP modes are chosen, the surface
temperature of the box may become higher than normal.
SSLOW ： Fan speed is very slow.
SLOW ： Fan speed is slow.
NOR ： Fan speed is normal.
FAST ： Fan speed is fast.
OK ： Normal
NG ： Fan is stopped.
Adjusts the horizontal phase when using external synch.
Sets so that the phase of the internal SYNC signal matches
the phase of the external SYNC signal. The internal SYNC
advances in the direction of -100 in relation to the external
synch, and delays in the direction of +100.
Can only be set during self-operation.
Sets the time and date when saving the file to the memory card.
See (Page 95) for the memory card usage method.
Saves the selected data to the memory card.
Loads all files.
Loads snapshot files.
Possible to select whether to load all from SCENE DATA or to
load individual data from 1 to 8.
Loads the reference file.
Possible to select whether to load all from LENS DATA or to
load individual data from 1 to 8.
Possible to select whether to load all menus from MENU
DATA or only those menus related to VF.
Description, Remarks
Selects the camera operation format.
If BS/CCU is connected, the format on the BS/CCU side and
the operation format will be the same.
When disconnecting the remote controller and operating by
the camera alone after adjusting the camera using the remote
controller.
Sets the semi-remote mode. The ON/OFF setting during remote
(control with remote controller, etc. connected) can be controlled
on the camera side with the GAIN changing switch, AWB
changing switch, output changing switch and SHUTT/SUP-V
switch on the right side of the camera.
In this case, control on the remote controller side is not possible.
MENU DATA
ALL VF
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
MENU DATA
ALL VF
- -
-
-