Ikegami HDK-55 Operation Manual page 77

2
Make sure that the ALARM indicator on the OCP or MCP is not flashing
When the camera self-diagnosis function detects errors, the ALARM indicator flashes, and the self-diagnosis information
will be displayed for 20 seconds.
OCP
O C P - 2 0 0
CAM PWR VF PWR
OFF
STANDARD CAP BARS CAL
TALLY
INFO OPE SETUP MAINTE
I O S
LENS EXT
FULL RELATIVE
KNOB
FREE
HEAD POWER
RANGE SENS
OPT
HEAD CCU
CABLE CLS OPEN ±1 ±2
OPEN SHORT
ALARM CALL PREVIEW
Note:
You can display the self-diagnosis information and check the status by pressing the PM IND/PAGE button even when the ALARM
indicator is not flashing.
■ To Control Power ON/OFF from OCP
It is possible to use the OCP to control the camera power source.
When the CAM POWER switch of OCP has been turned ON/OFF, only the camera power supply is turned ON/OFF. The BS power supply is not
turned ON/OFF.
PM IND PANEL
/ PAGE ENABLE
PM IND/PAGE
AWB ABB button
AWB ABB
USER WFM/PM
M U W
IRIS
ALARM indicator
PED
HDK-55 1206 VER1 (U)
MCP
MIX
R G B Y
SEQ
SUP
4.3 Turning ON Power
61
4