Mounting And Removing The Viewfinder - Ikegami HDK-55 Operation Manual

Mounting and Removing the Viewfinder
■ Mounting the Viewfinder
This section explains how to mount the viewfinder (VF421HD) to the camera.
1
Make sure the camera power switch is OFF.
If the power switch is set to BS/CCU or EXT, turn it OFF.
2
Tilt the viewfinder eyepiece upward 90 degrees.
3
Slide the rail on the rear of the viewfinder into the
guide on the front of the camera from the left-
hand side.
Slide the viewfinder until it clicks into position. When
the viewfinder is locked to the camera by the lock pin,
it clicks.
4
Connect the viewfinder cable to the viewfinder
connector on the camera handle.
Align the pins on the viewfinder cable with the
viewfinder connector and push until the connector
lock button clicks.
CAUTION:
Be careful not to catch your fingers in the lock lever or
guide-rail when attaching the viewfinder. Take caution
to avoid injury.
3.2 Camera and Peripheral Installation and Connection
③
Slide the viewfinder
into the guide.
HDK-55 1206 VER1 (U)
②
Tilt the eyepiece
upward 90 degrees.
④
Insert the viewfinder cable into
the viewfinder connector.
3
43