YASKAWA CC-Link Installation Manual page 42

8 CC-Link Data Table
Device
External Baseblock
RY9
Command
RYA External Fault
RYB Reserved
RYC Monitor Reference
RYD, E Reserved
Command Code Execute
RYF
Request
RY10 Terminals M1-M2 Function
Terminals P1-PC
RY11
Function
Terminals P2-PC
RY12
Function
RY13 Reserved
RY14 Terminal S1 Function
RY15
Terminal S2 Function
RY17 Enabled/Disabled
RY16
Selection
Terminal MA/MB-MC
RY17
Function
RY18, 19
Reserved
RY1A Fault Reset
RY1B
Reserved
to 1F
<1> Terminals will differ depending on the model of the drive. Refer to
Model of the Drive on page 46
Note: Although RYF is triggered by the rising edge of the signal, they are otherwise enabled depending
on the value that is input.
42
Name
ON: Motor coasts to stop.
OFF: Energy-saving unit will
begin operating as soon as a Run
command is given.
ON: External Fault Input (EF0)
ON: Monitor data specified in the
monitor code is set to remote
register RW
Request to execute the command
code.
Multi-Function Relay Output 1
(terminal M1-M2)
Multi-Function Photocoupler
Relay Output 1 (terminal P1-PC)
<1>
Multi-Function Photocoupler
Relay Output 2 (terminal P2-PC)
<1>
Multi-Function Input: H1-01
Multi-Function Input: H1-02
Fault Contact Output (terminal
MA/MB-MC)
Resets an energy-saving unit fault.
for information on terminals.
YASKAWA ELECTRIC TOBP C730600 83C YASKAWA AC Drive Option SI-C3 Installation Manual
Description
–
.
R0
–
–
–
–
–
Terminals that Change depending on the
Default
–
–
–
When switching between monitors
using RYC (Monitor Reference),
RYC needs to be turned off and
then back on again after the
monitor code has been changed.
–
Triggered by the rising edge of the
signal.
–
–
–
–
Function is disabled when for the
Run Command (H1-01 = 4B).
Function is disabled when for the
Stop Command (H1-02 = 4C).
–
–
–
–
–