Procedure
1. Loosen the screw
2. Pull the transparent cover
3. Tighten every cable in the corresponding terminal.
4. Slide the transparent cover
5. Tighten the screw
6. Connect the cables of each switch to the lug of the printed circuit board in pairs. Use the
5.2.6
Option device version M12 connector
This section describes which terminal of the devices and option modules listed below is
connected with the respective pole of the M12 connector.
Note
Technical specifications
Observe the specifications for the electrical data in the certificate and/or in section "Technical
data (Page 283)".
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
①
on the transparent cover
①
of the transparent cover
③
provided cable ties
①
Screw
②
Cover
③
Cable tie
Figure 5-12
Connecting the cables
②
up to the front end stop.
②
up to the end stop of the basic electronics.
for this purpose.
②
.
②
.
Connect
5.2 Electrical wiring
93