Siemens SIPART PS2 Operating Instructions Manual page 60

Installing/mounting
4.7 Installing the optional modules
⑪
Adapter
⑫
Transmission ratio selector
Figure 4-10 Installing the optional modules in the "flameproof enclosure" version
General procedure for optional modules in the "flameproof enclosure" version
1. Disconnect the power supply lines or de-energize them.
2. Open the safety catch
3. Unscrew the screw cap
4. Completely dismount the positioner from the actuator.
5. The positioner comes with a ring gear
6. Unlatch the four fixing screws
7. Completely remove the adapter
8. Remove the module cover
9. Install the optional modules as described in the corresponding sections for the individual
10.Now start with the assembly. Install the module cover
60
interlock and ensure backlash-free position feedback. To ensure backlash-free position
feedback make sure you remove the adapter
⑲
shaft on the positioner until the pin (feedback lever bracket)
shows in the direction of removal. You determine the position of the pin by looking into the
enclosure below the adapter. Now, the pin can be easily removed from the ring gear
Note
Damage to the ring gear
The ring gear consists of two washers fastened staggered to each other. This offset ensures
that path detection is backlash-free.
● Do not change this offset mechanically.
NOTICE
Displaced O-rings
There are several O-rings between adapter
off during removal.
● Carefully remove the adapter. Make sure the O-rings do not get lost during removal.
optional modules.
counter clockwise until they noticeably engage in the thread pitch. The module cover
protects and locks the optional modules mechanically.
Note
Untimely wear
The module cover is fastened using a self-tapping screw for the valve.
● Proceed as described here in order to avoid premature wear of the valve.
Carefully tighten both fixing screws
Enclosure
23
.
21
⑮
.
and a pin (feedback lever bracket)
22
⑳
.
⑪
from the enclosure
⑪
①
. Unlatch both screws
②
in a clockwise direction.
⑪
carefully. To this end, turn the feedback
⑯
below the adapter
.
23
and enclosure . These O-rings may come
23
②
using a screwdriver.
①
. To this end, turn the screws
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
⑰
which
⑪
.
22
②