Siemens SIPART PS2 Operating Instructions Manual page 132

Commissioning
7.6 Commissioning part-turn actuators
1. Switch to the "Configuration" mode. To do this, press the
2. Use the
3. Call the "2.YAGL" parameter. To do this, briefly press the
4. Call the "4.INITA" parameter. To do this, briefly press the
5. Start the initialization process. To do this, press the
6. The following display indicates that the automatic initialization is complete. The total angle
132
until the display shows the following:
button to change from linear actuator to part-turn actuator until the display shows
the following:
already been set to 90° automatically. The display shows the following:
following:
the display shows the following:
The positioner runs through five initialization steps during the automatic initialization
process. Displays for the initialization steps from "RUN1" to "RUN5" are shown in the lower
line on the display. The initialization process depends on the actuator used, and takes up
to 15 minutes.
of rotation of the actuator is shown on the upper line on the display:
button for at least 5 seconds
button. This parameter has
button. The display shows the
button for at least 5 seconds until
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB