Connect
5.2 Electrical wiring
Wiring diagram
①
②
③
④
⑤
⑥
⑦
Figure 5-7
Preparing the positioner
1. You have performed the steps described in the section "General information about the
2. Unplug the ribbon cable connector
3. Remove the basic electronics
4. Loosen screw
88
EMC filter module terminals
Positioner with integral EMC filter module
C73451-A430-D23
Yellow wheel for locking the position detec‐
tion
Ribbon cable connector of fitted potentiom‐
eter, or ribbon cable connector of EMC filter
module
Basic electronics
Screw
EMC filter module C73451-A430-D23
Connection to positioner
installation of option modules (Page 54)".
⑤
.
that fix the basic electronics to the pneumatic block.
⑥
in the connection area of the positioner.
⑧
External position detection system C73451-
A430-D78
⑨
External position detection system termi‐
nals
⑩
External position detection system cable
gland
⑪
Cable
⑫
EMC filter module cable gland
⑬
Input signal for positioner
④
to the fitted potentiometer from the basic electronics
⑤
from the positioner. To this end, remove the two screws
Operating Instructions, 02/2016, A5E00127926-AB
SIPART PS2 with PROFIBUS PA