Introduction; Purpose Of This Documentation; History - Siemens SIPART PS2 Operating Instructions Manual

Introduction

1.1

Purpose of this documentation

These instructions contain all information required to commission and use the device. Read
the instructions carefully prior to installation and commissioning. In order to use the device
correctly, first review its principle of operation.
The instructions are aimed at persons mechanically installing the device, connecting it
electronically, configuring the parameters and commissioning it, as well as service and
maintenance engineers.
1.2

History

This history establishes the correlation between the current documentation and the valid
firmware of the device.
The documentation of this edition applies to the following firmware:
Edition
02/2016
The most important changes in the documentation as compared to the respective previous
edition are given in the following table.
Edition
02/2016
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
Firmware code
FW 6.00.00 or higher
Note
1. Section Installing/mounting (Page 37) > Simpler commissioning of part-turn actuators
using coupling wheel with two pins.
2. New parameters and values in section Parameter assignment (Page 145):
– 1.YFCT - Actuator > Initialization of actuators with inverted direction of action is
now possible. Linear actuator > Mounting with carrier pin on actuator stem using
'FWAY/-FWAY' parameter value is now possible.
– 48.PRST - Preset > Resetting of individual parameter groups is now possible.
– 49.PNEUM > Fail in place function can now be activated with appropriate pneumatic
system.
3. New functions for the diagnostics parameters > section Partial stroke test 'A.\\PST'
(Page 173):
– A5.RPMD and A6.RPRT > Partial stroke test is now possible in ramp mode.
– A7.FLBH > Response following failed PST can now be defined.
4. New functions for the diagnostics values in section Diagnostics (Page 252):
– 7.HOURR > Resettable operating hours counter added.
– 11.LEAK > Offline leakage test added.
– 21.P0 and 22.P100 > Modification of upper and lower endstops now possible
without initialization.
– 25.PAUTP > Adjustable pulse pause added.
1
13