Siemens SIPART PS2 Operating Instructions Manual page 89

5. Insert the connector of the ribbon cable (A) into the slot as shown below.
6. Secure the EMC filter module using the screw
7. Fit the basic electronics
8. Insert the ribbon cable connector
9. In non-hazardous environment:
Refer to section "Scope of delivery of external position detection system (Page 307)", items
"Nameplate for device version without explosion protection" and "Gray cable gland".
Procedure for connecting an external position detection system
1. Connect the three terminals of the external position detection system
2. Tighten the cable glands
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
Note: There is no space for the ribbon cable (A) in earlier versions of the positioner. Here
you fasten the ribbon cable with the supplied cable tie at the container.
electronics.
– Stick the supplied nameplate over the nameplate on the external position detection
⑧
system .
– Replace the blue cable gland
terminals of the EMC filter module
⑤
back into the positioner.
④
of the EMC filter module onto the positioner basic
⑩
by the supplied gray cable gland.
①
using a cable as shown in the wiring diagram.
⑩ ⑫
and .
⑥
loosened in the third step.
Connect
5.2 Electrical wiring
⑨
to the three
89