Yagl' Rated Angle Of Rotation Of Feedback - Siemens SIPART PS2 Operating Instructions Manual

Factory setting:
9.3.1.2

'2.YAGL' Rated angle of rotation of feedback

Requirement:
Possible settings:
Purpose:
Factory setting:
SIPART PS2 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00127926-AB
Meaning for actuator with inverted direction of action:
● Part-turn actuator closes when the drive shaft, positioner shaft
or magnet of the NCS sensor rotates in the anti-clockwise
direction.
● Linear actuator closes when the actuator spindle rotates
downwards and the positioner shaft or magnet of the NCS sensor
rotates in the clockwise direction.
Additional information:
● The '3.YWAY' Range of stroke (Page 156) parameter is
displayed only for 'WAY', '-WAY', 'ncSLL' or '-ncLL'.
● turn/-turn: The '2.YAGL' Rated angle of rotation of feedback
(Page 155) parameter is automatically set to 90° and cannot be
changed.
● WAY/-WAY: The positioner compensates the non-linearity
caused due to the transformation of the linear movement of the
linear actuator into the rotary movement of the positioner shaft.
For this purpose, the positioner is set in the factory in such a way
that it displays a value between 'P49.0' and 'P51.0' when the
lever on the positioner shaft is perpendicular to the linear
actuator spindle.
WAY
Transmission ratio selector and the value set in the '2.YAGL' pa‐
rameter match. Only then does the value shown on the display
match the actual position.
● 33°
● 90°
Use this parameter for a linear actuator. For a linear actuator, set
an angle of 33° or 90° depending on the range of stroke. The current
setting of the actuator is then measured more accurately. The fol‐
lowing is applicable:
● 33°: Strokes ≤ 20 mm
● 90°: Strokes 25 ... 35 mm
● 90°: Strokes > 40 ... 130 mm
Use the mounting kit:
● 6DR4004-8V for strokes up to 35 mm
● 6DR4004-8L for strokes greater than 35 up to 130 mm
'2.YAGL' can only be adjusted if '1.YFCT' is set to 'WAY'/'-WAY' or
'FWAY'/'-FWAY'.
With all other settings of '1.YFCT', an angle of 90° is automatically
set for '2.YAGL'.
33°
Parameter assignment
9.3 Description of parameters
155