Through-Mount Version Air-Cooler Ip20, Ip54; Figure 7: Dimensions Through-Mount Version Air-Cooler Ip20, Ip54 - KEB COMBIVERT F6 Instructions For Use Manual

DIMeNSIONS AND WeIGHTS

3.3.3 Through-mount version air-cooler IP20, IP54

Housing
Weight
Dimensions
Figure 7: Dimensions through-mount version air-cooler IP20, IP54
42
29
317
373
356
187,5
41,5 125
All dimensions in mm
IP54 zone: heat sink underneath the mounting plate.
For proper installation, the enclosed seal (40F6T45-0002) must be installed
between heat sink and housing (e.g. cabinet wall). The tightness must be
checked after the installation. If properly installed, the separation to the housing
corresponds to degree of protection IP54. However, the fans must be protected
against unfavorable environmental influences. These include combustible, oily
or dangerous fumes or gases, corrosive chemicals, coarse foreign bodies and
excessive dust. This applies especially to the access of the heatsink from the
top (air outlet). Icing is inadmissible.
IP20 zone: device above the mounting plate.
Power connections excluded =>
is intended for the installation in a suitable housing for the required degree of
protection (e.g. control cabinet).
UL: Unit heat sink is classified as NEMA type 1.
27
125 (43,5)
4
13.6 kg
„Climatic environmental
200
202
132
262
conditions". This part