Notes On Use - GRAPHTEC midi LOGGER GL220 User Manual

Thank you for purchasing the GL220 midi LOGGER.
Please read this manual thoroughly before attempting to use your new product to ensure that you use it
correctly and to its full potential.

Notes on Use

Be sure to read all of the following notes before attempting to use the GL220 midi LOGGER.
1. Note on the CE Marking
The GL220A complies with the EN61326 (Class A) standard based on the EMC directive (89/336/EEC).
It also conforms to the EN61010-1 standard based on the LV directive (72/23/EEC)
Although the GL220 complies with the above-mentioned standards, be sure to use it correctly in accordance with the
instructions and notes provided in its User's Manual.
Moreover, use of the GL220 by incorrect procedures may result in damage to the GL220 or may invalidate its
safeguards. Please confirm all of its notes regarding use and other related information to ensure correct use.
2. Warning
This is a Class A product according to the EMC directive. In a domestic environment, this product may cause radio
interference or may be affected by radio interference to the extent that proper measurement cannot be performed.
3. Notes for Safe Operation
(1) Be sure to use the Graphtec-supplied AC adapter. In environments where there is a lot of noise or where the
power supply is unstable, we recommend that you ground the GL220.
(2) When a high-voltage signal cable has been connected to the main unit's analog signal input terminal, avoid
touching the leads of the input terminal's signal cable to prevent electrical shock due to high voltage.
(3) Ensure that the GL220's power source is positioned so that it can easily be disconnected.
4. Notes on Functions and Performance
(1) Be sure to connect the main unit to an AC or DC power supply that conforms to the rated range.
Connection to a non-rated power supply may cause the main unit to overheat and break down.
(2) Do not block the vent on the main unit.
Continued operation with the vent blocked may cause the main unit to overheat and break down.
(3) To avoid malfunctions and other damage, avoid using the GL220 in the following locations.
• Places exposed to high temperature and/or high humidity, such as in direct sunlight or near heating equipment.
(Allowable temperature range: 0 to 45°C (0 to 40°C when a battery pack is mounted), Allowable humidity range:
5 to 85%R.H.)
• Locations subject to excessive salt spray or heavy fumes from corrosive gas or solvents.
• Excessively dusty locations.
• Locations subject to strong vibrations or shock.
• Locations subject to surge voltages and/or electromagnetic interference.
(4) If the main unit becomes soiled, wipe it off using a soft, dry cloth. Use of organic solvents (such as thinner or
benzene) causes deterioration and discoloration of the outer casing.
(5) Do not use the GL220 in the vicinity of other devices which are susceptible to electromagnetic interference.
(6) Measured results may not conform to the stated specifications if the GL220 is used in an environment which is
subject to strong electromagnetic interference.
Introduction
Introduction
I