Danfoss VLT AAF00x Instruction Manual page 75

How to Program
8-35 Minimum Response Delay
Range:
10 ms [Application
*
dependant]
8-36 Max Response Delay
Range:
Application
dependent
*
6 6
8-37 Max Inter-Char Delay
Range:
Application
dependent
*
8-53 Start Select
Option:
[0] Digital
input
[1] Bus
[2] Logic
AND
[3] Logic OR
*
NOTE!
This parameter is active only when 8-01 Control Site is set
to [0] Digital and control word.
6-16
VLT Active Filter AAF 00x
Function:
Specify the minimum delay time
between receiving a request and
transmitting a response. This is used
for overcoming modem turnaround
delays.
Function:
[Application Specify the maximum
dependant] permissible delay time
between transmitting a
request and receiving a
response. Exceeding this delay
time will cause control word
timeout.
Function:
[Application Specify the maximum
dependant] permissible time interval
between receiving two bytes.
This parameter activates
timeout if transmission is
interrupted.
This parameter is active only
when 8-30 Protocol is set to FC
MC [1] protocol.
Function:
Select control of the unit start function via the
terminals (digital input) and/or via the Serial
communication bus.
Activates Start command via a digital input.
Activates Start command via the serial
communication port or Serial communication
bus option.
Activates Start command via the Serial
communication bus/serial communication port,
AND additionally via one of the digital inputs.
Activates Start command via the Serial
communication bus/serial communication port
OR via one of the digital inputs.
MG.90.V2.22 - VLT
8-55 Set-up Select
Option: Function:
Select control of the unit set-up selection via
the terminals (digital input) and/or via the Serial
communication bus.
[0] Digital Activates the set-up selection via a digital input.
input
[1] Bus Activates the set-up selection via the serial
communication port or Serial communication
bus option.
[2] Logic Activates the set-up selection via the Serial
AND communication bus/serial communication port,
AND additionally via one of the digital inputs.
[3] Logic OR Activate the set-up selection via the Serial
*
communication bus/serial communication port
OR via one of the digital inputs.
NOTE!
This parameter is active only when 8-01 Control Site is set
to [0] Digital and control word.
®
is a registered Danfoss trademark