Advertisement
Quick Links
Safety Guide
Advanced Active Filter AAF 007
Installation Safety
1 Installation Safety Instructions
1.1 Overview
This safety guide is to be used only to install the filter. When programming or operating the filter, refer to the operating guide for
applicable safety instructions. To install this product safely:
•
Check that the content of the delivery is correct and complete.
•
Never install or start up damaged units. File a complaint immediately to the shipping company, if the unit is damaged when
received.
•
Follow the instructions provided in this safety guide and the accompanying installation guide.
•
Make sure that all personnel working on or with the filter have read and understood this guide and any additional product
manuals. If further clarification or information is needed, contact Danfoss.
1.2 Target Group and Necessary Qualifications
Correct and reliable transport, storage, installation, operation, and maintenance are required for the trouble-free and safe operation
of the filter. Only skilled personnel are allowed to perform all related activities for these tasks. Skilled personnel are defined as prop-
erly trained staff, who are familiar with and authorized to install, commission, and maintain equipment, systems, and circuits in ac-
cordance with pertinent laws and regulations. Also, the skilled personnel must be familiar with the instructions and safety measures
described in this manual and the other product-specific manuals. Non-skilled electricians are not allowed to perform any electrical
installation and troubleshooting activities.
1.3 Safety Symbols
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates information considered important, but not hazard-related (for example, messages relating to property damage).
1.4 General Safety Precautions
LACK OF SAFETY AWARENESS
This guide provides important information on preventing injury and damage to the equipment or the system. Ignoring this infor-
mation can lead to death, serious injury, or severe damage to the equipment.
-
Make sure to fully understand the dangers and safety measures present in the application.
-
Before performing any electrical work on the filter, lock out and tag out all power sources to the filter.
Danfoss A/S © 2022.12
D A N G E R
W A R N I N G
C A U T I O N
N O T I C E
W A R N I N G
BH423927034786en-000101 / 130R1269 | 1
Advertisement
Related Manuals for Danfoss AAF 007
Summary of Contents for Danfoss AAF 007
- Page 1 • Make sure that all personnel working on or with the filter have read and understood this guide and any additional product manuals. If further clarification or information is needed, contact Danfoss. 1.2 Target Group and Necessary Qualifications Correct and reliable transport, storage, installation, operation, and maintenance are required for the trouble-free and safe operation of the filter.
- Page 2 Advanced Active Filter AAF 007 Safety Guide Installation Safety Instructions W A R N I N G HAZARDOUS VOLTAGE Filters contain hazardous voltage when connected to the AC mains. Failure to perform installation, start-up, and maintenance by skilled personnel can result in death or serious injury.
- Page 3 Advanced Active Filter AAF 007 Safety Guide Installation Safety Instructions W A R N I N G ELECTRICAL SHOCK AND FIRE HAZARD The filter can cause a DC current in the PE conductor. Failure to use a Type B residual current-operated protective device (RCD) may lead to the RCD not providing the intended protection and therefore may result in death, fire, or other serious hazard.
- Page 4 Danfoss can accept no responsibility for possible errors in catalogs, brochures, and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed.