Danfoss VLT AAF00x Instruction Manual page 54

How to Operate the Active F...
It is possible to switch directly between Quick Menu mode
and Main Menu mode.
[Main Menu]
is used for programming all parameters.
The Main Menu parameters can be accessed immediately
unless a password has been created via 0-60 Main Menu
Password, 0-61 Access to Main Menu w/o Password,
0-65 Quick Menu Password or 0-66 Access to Quick Menu w/o
Password.
It is possible to switch directly between Main Menu mode
and Quick Menu mode.
Parameter shortcut can be carried out by pressing down
the [Main Menu] key for 3 seconds. The parameter shortcut
allows direct access to any parameter.
[Alarm Log]
displays an alarm list of the five latest alarms (numbered
A1-A5). To obtain additional details about an alarm, use
the arrow keys to navigate to the alarm number and press
[OK]. Information is displayed about the condition of the
unit before it enters alarm mode.
[Back]
reverts to the previous step or layer in the navigation
structure.
[Cancel]
the last change or command will be canceled as long as
the display has not been changed.
[Info]
displays information about a command, parameter or
function in any display window. [Info] provides detailed
information when needed.
Exit Info mode by pressing either [Info], [Back] or [Cancel].
Navigation keys
The four navigation arrows are used to navigate between
the different choices available in [Quick Menu], [Main
Menu] and [Alarm Log]. Use the keys to move the cursor.
[OK]
is used for choosing a parameter marked by the cursor
and for enabling the change of a parameter.
VLT Active Filter AAF 00x
Operation keys
for local control are found at the bottom of the control
panel.
[Hand on]
enables control of the filter via the LCP. The key can be
Enabled [1] or Disabled [0] via 0-40 [Hand on] Key on LCP
The following control signals will still be active when
[Hand on] is activated:
NOTE!
External stop signals activated by means of control signals
or a serial bus will override a "start" command via the LCP.
[Off]
stops the unit. The key can be Enabled [1] or Disabled [0]
via 0-41 [Off] Key on LCP. If no external stop function is
selected and the [Off] key is inactive, the unit can only be
stopped by disconnecting the line power supply.
[Auto on]
enables the unit to be controlled via the control terminals
and/or serial communication. When a start signal is applied
on the control terminals and/or the bus, the unit will start.
The key can be Enabled [1] or Disabled [0] via 0-42 [Auto
on] Key on LCP.
®
MG.90.V2.22 - VLT is a registered Danfoss trademark
On OK
Warm
Alarm
Hand Auto
O
on
•
[Hand on] - [Off] - [Auto on]
•
Reset
•
Stop command from serial communication
Reset
on
5-3
5 5