Danfoss VLT AAF00x Instruction Manual page 62

How to Program
6.1.8 Parameter Selection
In main menu mode, the parameters are divided into groups. Select a parameter group with the navigation keys.
The following parameter groups are accessible:
Group Title
0-** Operation/Display
5-** Digital In/Out
8-** Communication and Options
14-** Special Functions
15-** Unit Information
16-** Data Readouts
300-** AF Settings
301-** AF Readouts
Table 6.1 Parameter groups
After selecting a parameter group, choose a parameter with the navigation keys.
The middle section on the GLCP display shows the parameter number and name, as well as the selected parameter value.
VLT Active Filter AAF 00x
Function
Parameters related to the fundamental functions of the filter, function of the LCP
buttons and configuration of the LCP display.
Parameter group for configuring the digital inputs and outputs.
Parameter group for configuring communications and options.
Parameter group for configuring special filter functions.
Parameter group containing filter information such as operating data, hardware
configuration, and software versions.
Parameter group for data readouts, e.g. actual references, voltages, control, alarm,
warning and status words.
Parameter group for setting the active filter. Apart from par. 300-10, Active Filter
Nominal Voltage, it is not recommended to change the settings of this parameter
group.
Parameter group for the filter readouts.
®
MG.90.V2.22 - VLT is a registered Danfoss trademark
6 6
6-3