Accelerator Damper Service; 200 Hour Service; Accelerator Damper Removal - SRAM RockShox RS-1 Service Manual

A c c e l e r a t o r D a m p e r ™ S e r v i c e
2 0 0 H o u r S e r v i c e
Some of the fasteners in this fork are reverse threaded. To avoid damaging the
fork when removing or installing a fastener, carefully read the instructions and
follow directional arrows.
Only use SRAM® Butter grease or Liquid O-Ring® PM600 military grease when
servicing RS-1™ forks. No other grease is approved for use.
When replacing seals and o-rings, use your fingers or a pick to remove the seal or
o-ring. Spray isopropyl alcohol on each part and clean with a rag.
Apply grease to the new seal or o-ring.
Inspect each part for scratches. Do not scratch any sealing surfaces when
servicing your suspension. Scratches can cause leaks.
Push the XLoc™ button in to the compressed (unlocked) position.
1
Position the fork horizontally in the bicycle stand. Remove the rebound
adjuster knob.
Place an oil pan beneath the fork to catch the draining oil.
2
Loosen the damper side bottom bolt 3 to 4 turns.
Strike the bottom bolt to dislodge the shaft from the stanchion.
3
Remove the bottom bolt.
A c c e l e r a t o r D a m p e r R e m o v a l
N OTI CE
5 mm
Mallet
Accelerator Damper™ Service
Flat blade screwdriver
5 mm
40