SRAM RockShox RS-1 Service Manual page 48

Clamp the cartridge tube into a bicycle stand with the bypass hole oriented
15
downward.
Pinch the glide ring closed against the piston, then thread the seal head
16
and rebound assembly into the cartridge tube.
While holding the cartridge tube in place, thread the damper seal head into
17
the cartridge tube and tighten the rebound assembly.
Remove the cartridge tube assembly from the bicycle stand, turn it over, and
18
clamp the cartridge tube assembly into the bicycle stand so the rebound
shaft is oriented downward.
Pull down on the rebound shaft.
22 mm 12.4 N·m (110 in-lb)
Accelerator Damper™ Service
Wrench
48