SRAM RockShox RS-1 Service Manual page 29

Apply SRAM® Butter to a new inner seal head o-ring. Install the seal head
5
on the rebound damper shaft.
Remove the bleed screw from the rebound damper seal head.
6
Insert the rebound adjuster knob into the rebound damper shaft until it
7
contacts the rebound adjuster screw. Rotate the knob counter-clockwise
until it stops to open the rebound.
Remove the rebound adjuster knob from the shaft.
Wrap a rag around the cartridge tube to absorb oil.
8
Install the rebound assembly into the cartridge tube. Tighten the rebound
seal head.
T10
2.5 mm hex or rebound adjuster knob
15 mm 9-10 N·m (80-90 in-lb)
Bleed Procedure 29