Carbon Fiber Upper Service - SRAM RockShox RS-1 Service Manual

2 0 0 H o u r S e r v i c e
Stabilize the carbon fiber upper on a bench top or on the floor. Place the tip
1
of a downhill tire lever under the wiper seal. Press down on the downhill tire
lever handle to remove the dust wiper seal.
Clean the inside and outside of the carbon fiber upper.
2
Remove the wire spring from a new wiper seal. Insert the narrow end of the
3
wiper seal into the recessed end of the flangeless seal installation tool.
Use a soft face mallet to gently tap the seal installation tool and push the
wiper seal into the leg until the seal contacts the bottom of the leg bore.
Install the outer wire spring.
C a r b o n F i b e r U p p e r S e r v i c e
32 mm

Carbon Fiber Upper Service

Mallet
52