SRAM RockShox RS-1 Service Manual page 21

Apply grease to the inner surface of the wiper seal.
4
Clamp the carbon fiber upper into a bicycle stand and position it at an angle
5
with the upper leg hole facing downward. Use the anchor tool to install the
anchor into the carbon fiber upper.
Make sure the wiper seal slides onto the tool without folding the outer lip of
the seal.
Tighten the anchor counter-clockwise. Remove the anchor tool from the
carbon fiber upper.
For easier installation, apply a thin layer of grease to the inside lip of the
anchor tool.
Position the carbon fiber upper at an angle with the upper leg hole facing
6
upward. Angle a syringe fitting in the upper leg hole so the oil will only
contact the inside of the leg.
Inject suspension oil into the carbon fiber upper leg.
Do not exceed the recommended oil volume as this can damage the fork.
Slide the stanchion with the spring assembly, air shaft first, into the carbon
7
fiber upper until it stops.
NOTICE
NOTICE
SRAM® Butter
Anchor tool
15wt RockShox® standard syringe
Carbon Fiber Upper Service
12 N·m (110 in-lb)
30 mm
10mL
21