SRAM RockShox RS-1 Service Manual page 41

Remove the stanchion from the carbon fiber upper.
4
If the stanchion does not slide out of the carbon fiber upper, the press fit of
the shaft may still be engaged. Reinstall the bottom bolt 2 to 3 turns and
repeat the previous step.
Insert the anchor tool into the bottom of the carbon fiber upper so that it
5
engages the damper anchor on the Accelerator Damper.™
Rotate the anchor tool clockwise and unthread the Accelerator Damper
6
assembly.
Remove the anchor tool from the carbon fiber upper.
The XLoc™ hose will spin as you loosen the anchor from the carbon fiber
upper. This is normal.
Guide the XLoc hose through the grommet while pulling down on the
7
anchor tool to reveal the Connectamajig.™
Remove the anchor tool.
Anchor tool
30 mm & anchor tool
Accelerator Damper Removal
Anchor tool
41