SRAM RockShox RS-1 Service Manual page 30

Reposition the Charger 2 Damper™ in the vise at an angle with the bleed
9
port angled as upward as possible.
Install the bottom bolt into the rebound damper shaft 3-4 turns.
Fill a bleed syringe half full with suspension oil. Slowly depress the plunger
10
to remove any air bubbles from the syringe.
Only use the syringe included with the RockShox Standard or Charger
Bleed kit. Do not use syringes that have been in contact with DOT brake
fluid. DOT brake fluid will permanently damage the damper.
Thread the syringe into the seal head bleed port.
11
Depress the plunger to pressurize the damper assembly.
Push the rebound damper shaft down. Keep pressure on the plunger as
12
the syringe fills with oil. Pull up slowly on the rebound damper shaft. Keep
pressure on the syringe as oil fills the system.
Repeat pushing and pulling the rebound damper shaft, keeping pressure on
the plunger, until only small bubbles emerge from the damper.
NOTICE
3wt RockShox® standard bleed syringe
Bleed Procedure 30