SRAM RockShox RS-1 Service Manual page 38

Remove the glide ring from the bottom of the lockout adjuster knob. Apply
4
grease and install a new glide ring.
Install the lockout adjuster knob on the knob base so the knob rotates from
5
open to closed. Install the low speed compression knob so the set screw in
the knob is aligned with the flat part of the lockout extension shaft.
Tighten the set screw.
This concludes the service of your RockShox® RS-1™ RLC suspension fork.
RLC
RLC
1.3 mm 0.3 N·m (2.5 in-lb)
Charger 2 Damper™ Installation - Crown Adjust
RLC
RLC
38