SRAM RockShox RS-1 Service Manual page 55

Install the anchor tool onto the Accelerator Damper™.
3
Insert the anchor tool and Accelerator Damper into the carbon fiber upper
while simultaneously pulling the XLoc™ hose through the leg.
Make sure the wiper seal slides onto the tool without folding the outer lip of
the seal.
Tighten the anchor counter-clockwise.
4
The XLoc hose will spin as you tighten the anchor. This is normal.
Remove the anchor tool.
Clean the inside and outside of the stanchion
5
Install the Maxle Ultimate™ through the dropout. Thread the bottom cap into
6
the bottom of the stanchion.
Leverage the Maxle Ultimate against a bench top, then tighten clockwise.
NOTICE
Anchor tool
30 mm
12 N·m (110 in-lb)
Accelerator Damper™ Installation
24 mm 12 N•m (110 in-lb)
55