SRAM RockShox RS-1 Service Manual page 36

Use a pick and needle nose pliers to remove the old crush washer from the
5
bottom bolt.
Hold the crush washer with needle nose pliers and unthread the crush
washer from the bolt by turning the bolt counter-clockwise with a 5 mm hex
wrench.
Dirty or damaged crush washers can cause oil to leak from the fork.
Install the bottom bolt and tighten.
6
Clean the entire fork.
7
200 Hour Service Continue the 200 Hour Service with
200 Hour Service Continue the 200 Hour Service with
NOTICE
Charger 2 Damper™ - Crown
Charger 2 Damper - Remote
5 mm & pick
5 mm 6.8 N·m (60 in-lb)
Installation.
Installation.
Charger 2 Damper™ Installation
5 mm & pliers
36