3.5
Accessories
Communication Interfaces
MVE soft starters support network communication via easy-to-install communications interfaces. Each soft starter can support
one communications interface at a time.
Available protocols:
Ethernet (Profinet, Modbus TCP, Ethernet/IP), Profibus, DeviceNet, Modbus RTU, and USB.
Ethernet/IP
DeviceNet
Modbus RTU
Modbus TCP
Profibus
Profinet
USB
Installing Communication Modules
•
Communication modules attach to the back of the controller:
LV motor test resistor assembly
LV motor test resistor assemblies are used for low voltage motor testing. They reduce the resistance across a phase arm,
increasing the strength of the non-conduction feedback signals. For more information, refer to Low Voltage Test Mode.
Starter Trip and Event Logger Software
The Starter Trip and Event Logger Software allows you to download the trip and event logs from the soft starter, for separate
analysis.
The software is compatible with all AuCom medium voltage soft starters using control software version 1.29 or later.
To use the Starter Trip and Event Logger Software with the MVE, the soft starter must be fitted with a USB Module (PIM-USB-01)
or a Modbus Module (PIM-MB-01).
For further information, or to download the software, visit www.aucom.com.
Protocol
GENERAL DESCRIPTION
Order code
PIM-EI-01
PIM-DN-01
PIM-MB-01
PIM-MT-01
PIM-PB-01
PIM-PN-01
PIM-USB-01
MVE User Manual (710-17074-00G) |
7
Need help?
Do you have a question about the MVE series and is the answer not in the manual?