Internal Fibre-Optic Connections - AuCom MVE series User Manual

6.18 Internal Fibre-Optic Connections

Internal fibre-optic cable connection diagram. This information is intended for panel builders.
1 Power assembly (including 3 phase arms)
A1-1 ~ A1-3 Non-conduction PCBs mounted at bottom of each phase arm
6 Non-conduction [Tx] connector
7 Firing [Rx] connector
A3 Interface PCB
2 Non-conduction status LEDs (green)
3 Firing [Tx] connectors and Firing status LEDs (red)
4 Non-conduction [Rx] connectors
5 Connectors to controller [Rx, Tx] and status LEDs (green / red)
A4 Controller
8 Connectors to interface PCB [Rx, Tx] and status LEDs (green / red)
NOTE
The connector sockets for the fixed fibre-optic Transmit (Tx) and Receive (Rx) are mounted on the Interface PCB (A3)
and on the three Non-conduction PCBs (A1-1, A1-2 and A1-3).
Transmit (Tx) fibre-optic sockets are light grey colour.
•
Receive (Rx) fibre-optic sockets are dark grey colour.
•
A4
RX
8
TX
E D
A3
PH1
TX PH1
PH2
RX PH2
5
PH3
PH3
2 3
4
A 1
6 7
A1-1
2
B
6 7
A1-2
C 3
6 7
A1-3
1
MVE User Manual (710-17074-00G) |
INSTALLATION
29