Table of Contents
Advertisement
Weatherproofer I Frame
Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, wheel lift, and pull hitch)
manually. Use a hoist or a forklift to move these
parts into position.
WARNING
ASSEMBLY INSTRUCTIONS
1. Place both frame halves on stands approximately 36"
high. The assembly area should be a large level area
of sufficient size to accommodate the
Weatherproofer I when fully assembled (See
Figure 3-1.)
2. Bolt frame halves together using 3/4-10 x 2-1/4 hex
head cap screws and hex lock nuts in the front and
rear plates. Bolt center frame halves together using
frame joint plate, 3/4-10 x 6 hex head cap screws,
and hex lock nuts. Leave all screws loose.
3. Level the frame halves.
4. Tighten all hardware to the recommended torques
shown in Table 2-1.
3-3
Advertisement
Table of Contents
