Table of Contents
Advertisement
1-8 X 7-1/2 HEX HEAD
CAP SCREW
2-1/2 HYDRAULIC
CYLINDER
17" SPRING
ASSEMBLY
REEL ARM
ASSEMBLY
CYLINDER TRUNNION
CYLINDER TRUNNION STOP
1/2 SPLIT LOCK WASHER
1/2-13 X 2-1/4 HEX HEAD
CAP SCREW
CHOPPER REEL/GANG
BAR ASSEMBLY
2410-9-24_chopper
Finishing Chopper Reel
Installation (Option)
NOTES
Refer to Figure 3-26 for hydraulic diagram for the
2410-6-24 model.
Refer to Figure 3-27 for hydraulic diagram for the
2410-7-24 model.
Refer to Figure 3-28 for hydraulic diagram for the
2410-9-24 model.
See Figure 2-5 for finishing chopper reel placement
dimensions.
1. Attach reel arm assemblies to rear frame in second
hole from top using 1-8 x 7-1/2 hex head cap screw,
5" pivot bushing, and hex lock nut (See Figure 3-29.)
2. Attach reel arms w/ extension assemblies to rear
frame using 1-8 x 7-1/2 hex head cap screws and
hex lock nuts.
Figure 3-29: Finishing Chopper Reel Installation (Option)
ASSEMBLY INSTRUCTIONS
3. Attach 17" spring assembly and 2-1/2 hydraulic
cylinder to lower hole on rear frame using cylinder
trunnion, cylinder trunnion stop, 1/2-13 x 2-1/4 hex
head cap screw, and split lock washer.
4. Install the manifold to the manifold bracket on the
frame using 1/2-13 x 3-1/2 hex head cap screws and
hex lock nuts.
5. Install fittings into manifold according to Figures 3-26
thru 3-28.
6. Install hoses per Figures 3-26 thru 3-28.
7. Install steel plugs in any remaining open manifold or
valve ports.
8. Attach chopper reel/gang bar assembly to reel arm
assemblies using gang bar mount plates, 3/4-10 x 6
hex head cap screws, and double hex lock nuts.
22
NOTE: SIDE PLATE HIDDEN
FOR CLARITY.
5" PIVOT BUSHING
1-8 X 7-1/2 HEX HEAD
CAP SCREW
1-8 HEX LOCK NUT
REEL ARM W/
EXTENSION
ASSEMBLY
3/4-10 HEX LOCK NUT
GANG BAR MOUNT
PLATE
3/4-10 X 6 HEX HEAD
CAP SCREW
3-35
Advertisement
Table of Contents
