Table of Contents
Advertisement
OPERATION AND MAINTENANCE
4. Check that tires are of proper size, load rating, and
inflated to manufacture specifications before
transporting. Check wheel lug bolts to insure
tightness.
1-1/2 X 16 LOCKOUT
1/8 HAIRPIN
CYLINDER STOP
L-PIN
2410 installed trans lock op
Figure 4-10: Installed Transport Locks
4-8
5. Know the transport heights and widths of the unit
before transporting. Attachments can increase the
transport dimensions of the implement. Use caution
when transporting near bridges and power lines.
Electrocution can occur without direct contact.
6. Raise the unit to full transport height.
7. Install transport locks on both lift cylinders. Do not
depend solely on implement hydraulics for transport.
(See Figure 4-10.)
Failure to use transport lock pins during
transport may result in permanent equipment
damage, serious injury, or death.
8. Transport during daylight hours whenever possible.
Always use flashing warning lights, except where
such use is prohibited by law. Make sure lights,
reflectors and SMV emblem are clearly visible and
operating. Remove any obstructions such as dirt,
mud, stalks or residue that restricts view before
transporting.
WARNING
WARNING
F-620-0912 Edition
Advertisement
Table of Contents
