Table of Contents
Advertisement
The Troubleshooting Guide, shown below, is included to
help you quickly locate problems that can happen using
your 2410 Weatherproofer I. Follow all safety precautions
stated in the previous sections when making any
adjustments to your machine.
PROBLEM
UNEVEN DEPTH
UNIT SIDE DRAFTS OR MOVES SIDE
TO SIDE
SHANKS PLUGGING WITH RESIDUE
SHANKS NOT PENETRATING
WHEEL BEARING FAILURE
DISC BLADES LOOSE AND/OR
SHEARING ROLL PIN
HYDRAULIC - ENTIRE UNIT SETTLING
DISC GANG PLUGGING
DISC GANG WILL NOT TURN OR
PUSHES SOIL
LIGHTS DO NOT WORK
Troubleshooting Guide
PROBABLE CAUSE
Unit not level when under power in the field
Excessive disc gang depth or down
pressure
Tire pressure too low
Unit not level front to rear
Lift wheels not carrying enough weight
Unit not level front to rear
Unit not level
Discs not cutting residue
Unit not level
Points worn
Triple-lip seals not installed correctly
Gang not tightened properly
Depth stop valve not working
Operating depth too deep
Conditions too wet
Depth set too deep for loose or wet
conditions
Gang bearing failure
Harness or lamp connection unplugged
Chapter 5
SOLUTION
Level unit front to rear (See "Leveling
(Front-to-Rear)" on page 4-4.)
Reduce machine depth.
Check inflation.
Adjust unit to be level.
Adjust depth stop and raise implement.
Adjust unit to be level.
Level machine (See "Leveling
(Front-to-Rear)" on page 4-4.)
Adjust machine depth.
Level unit front to rear (See "Leveling
(Front-to-Rear)" on page 4-4.)
Install new points.
Install seals with the lips pointing outward
away from the hub.
Retighten gang shafts to 1200-1500 ft-lbs.
If gangs have ran loose, gangs may
require disassembly to remove soil to
properly torque gang shafts. Replace
any worn components, shafts/spools,
etc.
Repair valve
Raise unit.
Wait until conditions more favorable.
Raise implement or wait until conditions
are more favorable.
Replace bearing
Check all harness/lamp connections to
verify that everything is properly
connected.
5-1
Advertisement
Table of Contents
