Appendix; Save Parameter To A Label - Weber Markoprint iJET Operating Manual

13 Appendix

13.1 Save parameter to a label

Step
1
There is the possibility to save parameter settings to a desired print
label. The function is advantageous if frequently changing products
should be print and these have different measurements and print
positions.
The menu item is in the control system available if the function
„Save parameter" is activated by iDesign software.
Requirements
The control system is connected via Ethernet or USB with a PC, on
which the iDesign software is installed.
Instruction
Please activate the function „Save parameter" in the iDesign
software as follows:
Procedure
Activate the function „Save parameter to a label" in the iDesign software
below Functions -> System settings -> Advanced settings.
After the function „Save parameter" is activated in the iDesign
software, select the menu item „Save parameter" in the menu
structure of the control system.
If a print label with saved parameter is selected, the saved
parameter will be used.
Page 95 of 127
Art. No.: 72801001
Appendix