Table of Contents
Advertisement
Art. No.: 72801001
Construction and function
5.5 SmartCard Functions
The SmartCard functions are supported by software version 2.016 and higher.
Automatic storage of the ink filling level in 1% steps. The correct ink level of a cartridge is always detected,
even by changing the cartridges. No more missing prints by interchanged cartridges.
Automatic detection of the ink type and automatic setting of the optimal ink paramaters. Ink volume, drop
size, nozzle voltage and firing time are stored on the SmartCard chip.
The current ink type is displayed for control and prevention of wrong cartridges.
Exact ink consumption calculation. The usable number of drops is calculated by the ink weight (g), specific
weight (g/ml) and drop size (in pl). The values are read out of the chip, depending on the ink type.
Warning message with expired shelf life - date of filling and shelf life are stored on the SmartCard chip
Warning message if cartridge is open for too long (installed life) - date of first insertion and maximum
operating time are stored on the SmartCard chip.
iDesign displays the ink part number for easy reordering.
Following data are stored on the SmartCard chip for checking claims:
Date of the first cartrigde insertion, serial number of the controller, firmware version of the controller
Date of the last cartridge insertion, serial number of the controller, firmware version of the controller
Number how many times the cartridge was used.
The ink type can not set manually by using SmartCard cartridges.
The ink level is set automatically and can not be reset.
Page 32 of 127
Advertisement
Table of Contents
