Table of Contents
Advertisement
8.23 Internal Pulse / Encoder
The print speed must relate to the conveyor speed. If the conveyor
speed is constant, the print speed can adjust fix, otherwise a shaft
encoder should be used, which measure the conveyor speed and
adapt the print speed continuous.
To adjust the parameter of the print speed,
1.
Touch the iLOGIK once in one of the status menus.
The Print image submenu is displayed.
2.
Call the System submenu by rotating the iLOGIK and select
by pressing.
The System submenu is displayed.
3.
Call the Internal pulse/Encoder submenu by rotating the
iLOGIK and select it by pressing.
4.
Adjust the value to internal (by constant running conveyor) or
to encoder (by non-constant running conveyor) by rotating the
iLOGIK and accept by pressing.
NOTE!
If the parameter Internal pulse is selected, the
conveyor speed must be detected and entered at the
system.
Make the input of the measured conveyor speed as follows,
1.
Touch the iLOGIK once in one of the status menus.
The Label submenu is displayed.
2.
Call the Speed submenu by rotating the iLOGIK and select by
pressing.
3.
Adjust the measured value by rotating the iLOGIK and accept
by touching.
Page 73 of 127
Art. No.: 72801001
Operation
Advertisement
Table of Contents
