Table of Contents
Advertisement
Art. No.: 72801001
Appendix
13.3 Cover installation
Step
1
2
Material damage due to improper print system
installation!
With the print system switched on, a defect may occur in
the system electronics.
Therefore:
–
Only install the system when it is switched off.
Required Resources
•
Setscrew wrench (Torx
Instruction
Please install the cover as follows:
Procedure
Disconnect both fixing bolts (this will used again) of the deflector and remove
it from the system unit. (see Fig. 13-1).
Fig. 13-5: Disassembly deflector
Put the Flexbracket-deflector on the system unit and tighten it with both fixing
bolts (see Fig. 13-6).
Page 100 of 127
®
) TX10
Advertisement
Table of Contents
