Installation; Controller Installing - Weber Markoprint iJET Operating Manual

Art. No.: 72801001
Installation and commissioning

7.2 Installation

7.2.1 Controller installing

When choosing the installation location the following conditions
apply:

Consider the generally accepted ergonomic criteria in
accordance with workplace ordinances as well as country-
specific legislation.

The installation location must be a dry and dust-free room,
ideally with an ambient temperature of approx. 18...25 °C.

The installation location may not be subject to fast temperature
fluctuations (condensation!).

Do not set up the controller directly next to or above hot
surfaces, since this will affect cooling of the controller.

If the controller is operated on a tripod (accessory), the stability
of the tripod on an even foundation must be ensured.

The controller may not be exposed to flammable, explosive,
corrosive gases or chemical vapours.

The controller may not be installed in the vicinity of high voltage
equipment or power supplies.

The controller may not be subjected to direct vibrations or
shocks.

Keep controller away from direct sunlight.

Keep controller away from oil or water.

The controller may not be exposed to strong magnetic or
electric fields.
Page 46 of 127