Table of Contents
Advertisement
Display
Menu
Zoom
Direction
Nozzle
Upside Down
Service
Reset Ink
Counter
Purge
Head
Temperature
USB stick
System
Time / Date
Sensor
Intern / Extern
Description
In the print width menu point, the number of pixels is increased or reduced. The
print image is therefore made wider or narrower.
In the case of barcodes, make sure that the change takes place in the correct
proportion.
Chapter 8.12, Page 64
The parameter print direction indicates the direction of movement of the product
on the conveyor belt viewed from the controller in the print direction.
Chapter 8.13, Page 65
Each ink cartridge has two rows of nozzles (A and B), for which different
settings can be made in the Nozzle Menu.
Chapter 8.14, Page 66
The setting Upside Down causes the print image to be printed upside down.
Chapter 8.15, Page 67
The settings ink counter, Purge nozzles and Nozzle heating can be made in the
service menu.
This function causes the ink level to be reset after inserting a new cartridge.
Chapter 8.16, Page 68
During the purging process ink is ejected from all the nozzle ducts.
N.B.: Protect the environment from pollution!
Chapter 8.18, Page 69
Indication of the temperatures and calibration of the warming setting.
Chapter 8.19, Page 69
NOTE: This menu item is only shown after connecting the iJET USB stick!
In this submenu it's possible to load data from the USB stick memory to the iJET
memory and to load data from the iJET memory to the USB stick memory.
Chapter 8.20, Page 70
System settings can be made in this menu.
Time and date are displayed in this menu and can be set here.
The light barrier to be used is set in this submenu. It is internally selected when
the sensor integrated in the housing is used, and Extern when an optionally
available sensor is used.
Page 57 of 127
Art. No.: 72801001
Operation
Advertisement
Table of Contents
