Table of Contents
Advertisement
Art. No.: 72801001
Faults
10.2 Table of faults
Disorder
Possible cause
Controller
No power supply
does not start
No screen
No signal from the system
display
Print head
No start pulse
does not
produce a
Print parameter incorrect
print image
Fault in the electronics of the
controller or the print head
Faulty rotary encoder or incorrect
rotary encoder settings
Pale and
Distance between print head and
blurred print
object too large
image
Low intensity
Ink cartridge empty
Closed nozzles
Troubleshooting
Check power supply
Start the system
Check photocell and
connection cable
Check print parameter, adjust
if necessary
Send controller or print head
in for repairs
Check rotary encoder and
encoder settings
Reduce distance to 0 - 4...5
mm
Raise intensity
Replace ink cartridge
Start spitting and wipe the
nozzle plate off, carefully
Page 82 of 127
Recovered by
Electrician
Instructed person
Electrician
Instructed person
Manufacturer
Instructed person
Specialist
Instructed person
Instructed person
Instructed person
Advertisement
Table of Contents
