Viewing The Rf Status - Cisco D9865 Installation And Operation Manual

Viewing the RF Status

To View the RF Status Information
Proceed as follows to view the RF status:
From the Info screen, select RF Status and press OK.
The following table describes the RF Status information displayed:
Downlink Frequency
Symbol Rate
Polarization
FEC
LO Freq 1/2
Crossover
AFC
Modulation System
4-82
RF Status
Indicates the current downlink frequency, in GHz.
Indicates the Symbol Rate of the received signal, in
MS/s.
Indicates the signal polarization setting. This setting
is only applicable when LNB Power is set to H-NIT
or V-NIT. The selected setting must match the
polarization of the transmitted signal.
Indicates the FEC (Forward Error Correction) rate of
the received signal.
Displays the Local Oscillator frequency #1 and #2.
Indicates the crossover frequency, which is an
internal threshold frequency used for selecting the
LO1 or LO2 frequency, depending on the current
Downlink frequency setting. This is only used in
Ku-Band dual LNB application.
Indicates the current Automatic Frequency Control
adjustment, in MHz.
Indicates the modulation type of the received signal.
D9865 Satellite Receiver Installation and Operation Guide
Description
4035197 Rev C