Pre-Selection Of Running Time; Pre-Selection Of Brake Intensity And Acceleration - Hermle Z 206 A Operating Manual

2.4.2 Pre-Selection of Running Time

The running time can be pre-selected in 3 different ranges: from 10 seconds up to 99 hours 59
minutes.
1. Range from: 10 seconds up to 59 minutes 50 seconds, in steps of 10 seconds
2. Range from: 1 hour up to 99 hours 59 minutes, in steps of 1 minutes
3. Range: Continuous Run "cont", can be interrupted by the key, "stop" (10).
-The running time can be pre-selected, with the lid opened or closed.
-To activate the setting of the running time, press the key "time" (6).
-In the display, "time" (A-3) flashes the indication: "m : s" or "h : m", depending on the
previous setting.
To set the desired value, use the adjustable knob (1). After exceeding 59 min 50 sec, the indication
changes automatically to, "h : m". After exceeding 99 hours 59 min, the word "cont" appears in the
display, "time" (A-3).
The continuous run can only be interrupted by pressing the key, "stop" (10). The time counts down,
as soon as the set speed is reached.
For all number marked text, please refer to, Figure 14.
Figure 14

2.4.3 Pre-Selection of Brake Intensity and Acceleration

Selecting the key, "accel/decel" (5), this function is activated.
By pressing the key once, the word "accel" (M7) flashes, in the display "accel/decel" (A-2). The
desired acceleration can be pre-selected, with the adjustable knob (1). The value 0 is equivalent to
the lowest acceleration and the value 9 is equivalent to the highest acceleration.
By pressing the key "accel/decel" (5) twice, in the display "accel/decel" (A-2), indicates the word
"decel" (M8). Now the desired brake intensity can be pre-selected, with the adjustable knob (1). The
value 9 is equivalent to the shortest possible brake time and the value 0 to longest possible brake
time.
See Table 5: "Acceleration and Deceleration Times", (See APPENDIX V). This table shows the
acceleration and deceleration times, for the acceleration and deceleration stages 0 to 9, for each
rotor.
© Hermle Labortechnik GmbH Z206A_V1.18_eng
OPERATION
15