Pre-Selection Of Running Time - Hermle Z 216 MK Operating Manual

OPERATION

2.3.2 Pre-Selection of Running Time

The running time can be pre-selected in 3 different ranges: from 10 seconds up to 99 hours 59
minutes.
1. Range from: 10 seconds up to 59 minutes 50 seconds, in steps of 10 seconds
2. Range from: 1 hour up to 99 hours 59 minutes, in steps of 1 minutes
3. Range: Continuous Run "cont", can be interrupted by the key, "stop" (10).
-The running time can be pre-selected, with the lid opened or closed.
-To activate the setting of the running time, press the key "time" (6).
-In the display, "time" (A-3) flashes the indication: "m : s" or "h : m", depending on the previous
setting.
To set the desired value, use the adjustable knob (1). After exceeding 59 min 50 sec, the indication
changes automatically to, "h : m". After exceeding 99 hours 59 min, the word "cont" appears in the
display, "time" (A-3). The continuous run can only be interrupted by pressing the key, "stop" (10).
The time counts down, as soon as the set speed is reached.
The display will always show the remaining running time, (see Figure 20)
For all number marked text, please refer to Figure 20.
Figure 20
20
Z216MK_V1.19_eng © Hermle Labortechnik GmbH