Declaration Of Atex (94/9/Eg); Following Rules - Hermle Z 206 A Operating Manual

1.6.4 Declaration of ATEX (94/9/EG)

The HERMLE Z 206 A is not "explosion-proof" and must therefore not be operated in explosion-
endangered areas or locations. During centrifugation, it is prohibited to stay within the safety zone of
30 cm/12in around the centrifuge or deposit hazardous substances, within this area. Centrifugation
of flammable, explosive and radioactive substances or substances, which chemically
react with high energy, is strictly prohibited! If used in such environment, this is at the users own
expense.
• Never spin toxic or pathogenic material without adequate safety precautions, i.e.
centrifugation of buckets / tubes with or without defective hermetic sealing, is strictly
prohibited. The user is obliged to perform appropriate disinfection procedures, in case
dangerous substances have contaminated the centrifuge and/or its' accessories. When
centrifuging infectious substances, always pay attention to the General Laboratory
Precautions. If necessary, contact your safety officer!
• It is prohibited to run the centrifuge, with rotors not manufactured for this unit.
• Under no circumstances open the lid of the centrifuge, while the rotor is still running or
rotating with a speed of > 2m/s.
This device may only be operated by a trained professional. Carefully, read the operating
manual and be familiar with the functions of the device.

1.6.5 Following Rules:

• Do not operate the centrifuge if not installed correctly.
• Do not operate the centrifuge when dismounted (e.g. without housing).
• Do not run the centrifuge, if mechanical or electrical assembly groups have been tampered
with, by unauthorized personnel.
• Do not use accessories such as rotors and buckets, that are not approved by HERMLE
Labortechnik GmbH, except commercially available centrifuge tubes, made of glass or
plastic.
• Do not spin extremely corrosive substances, as they may cause material damages and impair
mechanical resistance.
• Do not operate the centrifuge with rotors or buckets, that show any signs of corrosion or
mechanical damage.
The manufacturer is responsible for safety and reliability, of the centrifuge, only if:
• The unit is operated in accordance to this instruction manual.
• Modifications, repairs or other adjustments are performed by HERMLE-authorized personnel
and the electrical installation of the related location corresponds to the IEC-regulations.
© Hermle Labortechnik GmbH Z206A_V1.18_eng
PRODUCT DESCRIPTION
5