Lid; Lid Release; Lid Lock - Hermle Z 206 A Operating Manual

2.3 Lid

2.3.1 Lid Release

After the run, properly close the lid of the centrifuge, appearing in the display, "rpm/rcf"(A-1) with the
word, "close" (M1). If there is a rotor in the centrifuge, the word, "rotor" (M3) appears, as well as the
code number of the specified rotor, which is in the centrifuge, for example "221.28" (M4). If there is
no rotor in the centrifuge, it flashes the word, "rotor" (M3) and an additional word, "no" (M4). ). By
pressing the key, "lid" (7), the lid of centrifuge can be released. As soon as the electromagnetic lid is
completely released, the word, "open" (M2) appears. The lid of the centrifuge is now able to be
opened.
For all number marked text, please refer to Figure 12.
Figure 12

2.3.2 Lid Lock

The lid must only be closed slightly. An electromagnetic lid lock closes the lid, the word "open" (M2)
will no longer be displayed. As a sign that the centrifuge is ready for starting, appearing in the
display, "rpm/rcf"(A-1), the word "close" (M1). Simultaneously, the word "rotor" (M3) appears, as
well as the code number of the rotor, which is in the centrifuge, i. e. „nr 96" (11) along with all rotor
specific data, for example: max. speed, acceleration etc., are available, (see Figure 12).
ATTENTION
Before closing the lid, please check if the rotor is tightened, and all 6 buckets are inside the
swing out rotor.
© Hermle Labortechnik GmbH Z206A_V1.18_eng
OPERATION
13