Pre-Selection Of Running Time; Pre-Selection Of Brake Intensity And Acceleration - Hermle Z 207 M User Manual

OPERATING

2.4.2 Pre-Selection of Running Time

The running time can be pre-selected in 3 different ranges: from 10 seconds up to 99 hours 59
minutes.
1. Range from: 10 seconds up to 59 minutes 50 seconds, in steps of 10 seconds
2. Range from: 1 hour up to 99 hours 59 minutes, in steps of 1 minutes
3. Range: Continuous Run "cont", can be interrupted by the key, "stop" (10).
- The running time can be pre-selected, with the lid opened or closed.
- To activate the setting of the running time, press the key "time" (6).
- In the display, "time" (A-3) flashes the indication: "m : s" or "h : m", depending on the
To set the desired value, use the control field (1). After exceeding 59 min 50 sec, the indication
changes automatically to, "h : m". After exceeding 99 hours 59 min, the word "cont" appears in the
display, "time" (A-3).
The continuous run can only be interrupted by pressing the key, "stop" (10). The time counts down,
as soon as the set speed is reached.
For all number marked text, please refer to Figure 15.
Figure 15

2.4.3 Pre-Selection of Brake Intensity and Acceleration

Selecting the key, "accel/decel" (5), this function is activated.
By pressing the key once, the word "accel" (M7) flashes, in the display "accel/decel" (A-2). The
desired acceleration can be pre-selected, with the control field (1). The value 0 is equivalent to the
lowest acceleration and the value 9 is equivalent to the highest acceleration.
By pressing the key "accel/decel" (5) twice, in the display "accel/decel" (A-2), indicates the word
"decel" (M8). Now the desired brake intensity can be pre-selected, with the control field (1). The
value 9 is equivalent to the shortest possible brake time and the value 0 to longest possible brake
time.
For all number marked text, please refer to Figure 16.
See Table 4: "Acceleration and Deceleration Times", (APPENDIX P. IV). This table shows the
acceleration and deceleration times, for the acceleration and deceleration stages 0 and 9, for
permissible rotors.
16
previous setting.
Z207M_V1.21_eng
© Hermle Labortechnik GmbH