OPERATION
2. OPERATION
2.1 Mounting and Loading the Rotor
2.1.1 Installation of the Rotor
Clean the drive shaft and the collet with a clean, grease-free piece of cloth. Place the rotor onto the
drive shaft, (see Figure 4). Please be sure that the rotor is fully installed onto the motor shaft)
Please be sure that the rotor shaft is completely plugged into the rotor slot, (see Figure 5).
Figure 4
Figure 5
Figure 6
Hold the rotor with one hand and secure the rotor to the shaft, by turning the fixing screw clockwise,
(see Figure 6).
ATTENTION:
For safety reasons, check the fixing screw before each run.
Do not operate the centrifuge with rotors or buckets, that show any signs of
corrosion or mechanical damage.
Do not operate with extremely corrosive substances, that could damage the rotor,
buckets and materials.
In case of any questions, please contact the manufacturer!
10
Z206A_V1.18_eng
© Hermle Labortechnik GmbH