Intellicenter Control System - Pentair IntelliCenter User Manual

98 |
Setup Wizard [Advanced System Configuration]
PUMPS
Tap Yes then Next to configure a new pump (Tap No then Next to continue to
Configure Heaters. See Pump Settings on page 62.
Create: Tap Create then Next to select a new pump type (Single Speed, Dual Speed,
IntelliFlo VS, IntelliFlo VF and IntelliFlo VSF) and configure the selected pump
settings.
Modify: Tap Modify then Next to display the list of configured pumps. Tap New
Pump to add a pump. From this screen you can add or delete pumps from the list.
When finished with setting up pump settings, tap Next to continue to the Configure
Heaters screen.
IntelliFlo VF Settings: Tap Settings: Pump Type (select a different type of pump),
Pump Name (enter a name for the pump), Pump Address: select an address for
the pump (1-16). Tap Back twice. Tap Flow Circuits.
Tap New Flow Circuits (to change the pump circuit). Flow (GPM): Tap the -/+
button to set the flow rate (15-134 GPM). Tap Next twice to add another pump or
tap Next twice to configure a heater.
IntelliFlo VS Settings: Tap Settings: Pump Type (select a different type of pump),
Pump Name (enter a name for the pump), Pump Address: select an address for
the pump (1-16). Tap Back twice. Tap Speed Circuits.
Tap Speed Circuits. Tap New Speed Circuits (to change the pump circuit). Speed
(RPM): Tap the -/+ button to set the pump speed (450-3450 RPM). Tap Next three
times to configure a heater.
IntelliFlo VSF Settings: Tap Settings: Pump Type (select a different type of pump),
Pump Name (enter a name for the pump), Pump Address: select an address for
the pump (1-16). Tap Back twice. Tap Speed/Flow Circuits.
Tap New Speed/Flow Circuits (to change the pump circuit).
Type: GPM/RPM): Select either GPM (20-140) or RPM (450-3450). Tap the -/+
button to set the speed (RPM) or Flow Rate GPM). Tap Next twice to add another
pump or tap Next twice to configure a heater.
Single Speed Pump Settings: Pump Type (select a different type of pump), Pump
Name, and Body (pool, spa or pool/spa). Tap Return then Next to continue and add
another pump or tap No twice to configure a heater.
Two Speed Pump Settings: Tap Settings: Pump Type (select a different type of
pump), Pump Name, Low Speed Circuit and High Speed Circuits. Select a circuit
for the low speed and the high speed. You can choose up to (4) four high speed
circuits.
IntelliCenter Control System User's Guide