Service Mode - Pentair IntelliCenter User Manual

Service Mode

Air Temp 65° F
SERVICE MODE
78° 85°
84° 92°
Pool Spa
Select High Speed Circuits
Schedule Usage
Enabling Service Mode will disable all circuits that are
currently active.
Auto
Service Mode
Enabling Service Mode will disable all circuits that are
currently active.
Auto
Manual Circuit Control
Manual Circuit Control
AUX2
AUX4
Spa Light
IntelliBrite
GloBrite
Service Mode
Enabling Service Mode will disable all circuits that are
currently active.
Auto Service
Manual Circuit Control
Time Out (hours)
Remaining Time
Tap Manual Circuit Control and choose
the circuits to enable. Note: Circuits
selected in the Service Manual Circuit
Control screen are retained in the Timer
Manual Circuit Control screen.
8:00 A.M.
3 3
Features Lights
Chemistry Status
Service Timer
Service Timer
AUX3
AUX5
Pool Light
MagicBowl
Landscape Lights
Timer
2
02 Hr 56 Min 50 Sec
Service Mode: Service and Timer mode
is used for pool/spa maintenance or
service purposes to manually control
and test system equipment. During
Service mode, the Outdoor Panel,
Indoor Control Panel and Wireless
Remote Home screen will display
SERVICE MODE. All system auxiliary
circuits will be disabled once Service
or Timer is selected. When AUTO is
selected, normal operation will resume
and the system will not be in service
mode.
Note: If the panel is passcode
protected, enter the four digit
assigned passcode, see page 45 for
details.
Auto: When Auto is selected it
indicates that the system is operating
normally and not in Service or Timer
mode.
Service: When Service is selected,
all system auxiliary circuits will turn
OFF. To enable auxiliary circuits select
Manual Circuit Control and choose the
system auxiliary circuits to turn on/off.
Manual Circuit Control: Choose the
auxiliary circuits to allow manual
control for shared equipment or dual
equipment). Tap the circuit name
to turn the circuit on/off. Note: For
shared equipment, only one valve can
be activated at a time.
Timer: Use the Timer mode to leave
the system in service mode up to 24
hours and automatically return to Auto
mode (normal system operation) after
the maximum hours set has elapsed.
Set the count-down timer from 1 to 24
hours for selected circuits to remain in
service mode.
IntelliCenter Control System User's Guide
| 37